gif
gif
gif

LOCATE  |  ABOUT  |  FAQ's - POLICIES  |  REVIEWS  |  PRIVACY  | 

shopping cart

gif
gif
gif gif gif  
gif gif gif gif gif

 

REMCO LUBE PUMP SYSTEM PARTS

You are on page 1 of 1

Southwest Driveline supplies repair parts along with individual components for all the Remco Lube Pump Systems. We are a Remco factory direct dealer, installation, service, parts and warranty center for all the Remco line of products, along with complete turn-key  installations at our facility in Yuma AZ. read more

NOTE: Complete Remco Lube Pump Systems are available for purchase here

INFO: Complete car side Lube Pump systems are available by contacting us at this time.


Remco Lube Pump fluid pump This is the latest model transmission fluid pump for the Remco Lube Pump Systems. This pump fits all Remco Lube Pump Systems from the beginning of time. Pump does not come with the chrome plated quick disconnect 90 degree hose fittings. You will use the chrome plated fittings from your defective pump. If your defective pump uses the old style brass screw-in hose fittings or you have no pump at all, you will need to purchase the chrome plated quick-disconnect fittings below to use with this pump. Pump is non-serviceable - No internal parts available.

NOTE: Remco voids the warranty if installed in front of radiators, wheel-wells, under vehicle or anywhere that the pump is subject to wet conditions

MFG #  11010046-N (-N designates, replacement pump)
MSRP: $214.00
Our Price $199.00

Electrical component (non-returnable)

In Stock
qty:

Lube Pump quick disconnect fittings Quick Disconnect Pump Fittings for the newest model Remco Pump (seen above). Your pump will have tabs that release these fittings in order to re-install. Do not confuse these new pump fittings with the old-style 1/4" brass barb pipe fittings. O-Ring included on each fitting. Pictured is (1) 5/16 hose output barb and (1) 3/8 hose input barb (most common). (sold as a pair)

Some newer pump systems use (2) 3/8" hose barb fittings. Purchase as your Lube Pump System requires

In Stock
qty:

Remco Hose Kit Authentic Remco Lube Pump hose kit. 8 foot lengths of (1) 5/16 id and (1) 3/8 id or (2) 3/8 id delivery and supply hoses. Don't make a mistake and use some off the wall hose for your Lube Pump System. Remco thoroughly tested numerous brands of hydraulic hose and settled on this brand both for burst pressure and ability to perform with all types and temperatures of transmission fluids. Through the years we have seen dozens of transmissions go-away just because of the replacement hose used. Will absolutely will not use any other hose in our facility. It's you dime, you decide! (sold as a pair)
In Stock
qty:

Lube Pump pressure switch Lube Pump selector valve Pressure Switch. Used on "ALL" Lube Pump Systems


Electrical component (non-returnable)
In Stock

qty:

Lube Pump pan fitting Remco Lube Pump transmission 90 degree pan oil pick-up fitting. Requires pan to be removed for installation. Does not use gaskets, seals to pan by use of Silicone Sealant (not included). Be very careful not to allow silicone to plug the fitting!
In Stock
qty:

Lube Pump system motorhome  monitor Lube Pump Monitor. This is the latest monitor from Remco. It has an On/Off switch on the front panel. This monitor can be used to replace all Remco Lube Pump Monitors of earlier generations including the horrible "smart monitor", the one with no On/OFF switch. (does not include pig-tail or instructions, sold as pictured)

THIS IS THE MONITOR ONLY
If you need a complete Remco Lube Pump system! Click here
Electrical component (non-returnable)

MFG# 41010017

In Stock
qty:

Pig tail to fit the above monitor Lube Pump Monitor "3' long controller pig tail". If you as an example, removed your Lube Pump Monitor only, then sold your Motorhome. You will need this pigtail along with the wire harness listed below to re-install your monitor into your new vehicle. The (2) together along with "your" monitor will make a complete motorhome side. (does not include monitor, curly cord, installation hardware or instructions)

MFG#  41010018

In Stock
qty:

Tow (motorhome side) wire harness Partial tow vehicle (motorhome) wire harness includes 6 pin trailer receptacle with 50' cable. Lube Pump electrical supply requires the tow vehicle to utilize a 3-way rear light system LT/B RT/B Tail. (does not include monitor, monitor pigtail, curly cord, installation hardware or instructions)

THIS IS THE MOTORHOME WIRE HARNESS ONLY.
If you need a complete Remco Lube Pump system! Click here
In Stock
qty:

Complete Motorhome side Lube Pump kit Complete Remco Lube Pump Motorhome tow-side wire harness including controller, controller pigtail, 50' wire harness w/6 pin female trailer plug. Everything you need for the tow-side (motorhome) wiring system. (no installation hardware - i.e. wire connectors, screws - sold as pictured)


THIS IS THE MOTORHOME SIDE MONITOR & WIRE HARNESS.
If you need a complete Remco Lube Pump system! Click here

Electrical component. (non-returnable)

In Stock
qty:

Complete Car Side Lube Pump system

for illustration only

THIS IS THE TOWED VEHICLE "CAR SIDE KIT ONLY". Remco Lube Pump car side kits come with everything you need for installation into your towed vehicle. Pump, wire harness, diodes, oil pan pick-up, both delivery and supply hoses, selector valve system, small parts kit and manual. (kit does not include curly cord or motorhome side)

If you need a complete Remco Lube Pump system! Click here

Electrical component. (non-returnable)

CALL US AT 928-782-3611 FOR DETAILS AND PRICING


6 wire electrical curly cord Original Remco "Curly Cord". 6 pin male connectors. Reversible from end to end. (sold as pictured)
In Stock
qty:

LP-1 Selector Valve

Remco Lube Pump LP-1 selector valve. You can also convert an LP-2, 7 or 8 to an LP-1 by use of this selector valve. Valve is used in LP-1 systems only. (sold as pictured)


Electrical component. (non-returnable)

In Stock
qty:

LP-2 Selector Valve Remco LP-2 selector valve. You can also use this selector valve to convert an LP-1, 7 or 8 to an LP-2 system. Used in LP-2 Lube Pump systems only. (sold as pictured)


Electrical component. (non-returnable)
In Stock
qty:

 
 
Page Last Updated 12/17/2014
Contents subject to change without notice
 
 

 |  Contact  |  About  |  Locate  |  Returns  |  FAQ's & Policies  |  Privacy  |  Terms  |  Reviews  |

Positive SSL on a transparent background

website security

   

Copyright © 1985-2014 Southwest Driveline Service. All rights reserved

All trademarks mentioned herein belong to their respective owners
SW Driveline Service is a dealer for Remco and Superior Driveline. We are an
individual entity and have no legal relationship with either manufacturer.
website design by, the old man